NEW PODCAST: Can Anyone Shoot an IMAX Film? From Production to the Big Screen – Focus Check ep142 →🎙️ WATCH/LISTEN Now
Watch/Listen NowCan Anyone Shoot an IMAX Film? 🎙️NEW PODCAST
Education for Filmmakers
Language
The CineD Channels
Info
New to CineD?
You are logged in as
We will send you notifications in your browser, every time a new article is published in this category.
You can change which notifications you are subscribed to in your notification settings.
The camera hack wave is not only about video. On the Ricoh GR III, GR IIIx and GR IV, three community projects add film looks, extra aspect ratios, a date imprint and the GR IV Monochrome’s black-and-white profiles, and on Hasselblad’s X2D cameras, independent developers added continuous autofocus, eye recognition and a 400MP pixel-shift mode. According to its developer, the autofocus project has gone offline at Hasselblad’s request. On the FUJIFILM X70, FujiMod adds 23 features, from a 65:24 aspect ratio to F-Log.
This is part six of our series on camera firmware hacks, and it is the one for photographers. The earlier parts covered fpSup on the SIGMA fp, the shutter-angle hack on the Sony a7 IV, Wonder Lantern on the Nikon Z30 and Magic Lantern on Canon DSLRs. CineD is mainly a filmmaking site, but these projects belong in the series because they show the same methods at work, from card-loaded scripts to fully patched firmware, and because the GR IV Monochrome looks and some of the FujiMod features also work in movie mode. As in the other parts, everything here is unofficial and at your own risk, and none of it is supported by Ricoh, Hasselblad or FUJIFILM.
GRKit is the least invasive of the Ricoh projects. It runs from the SD card and, according to its developer, never writes to the firmware: take the card out, and the camera is back to stock. Press the ADJ lever while shooting and a sixth item, GRK, gives you film looks such as Portra 400, Velvia 100 and Tri-X 400 with a live preview, framing options from XPan and 2.35:1 to 16:9, 4:3, 5:4, 7:6 and 1:1 with a mask or frame lines, composition guides, a date imprint in three styles and film grain in four strengths. A new Glow section adds Bloom, which spreads light around highlights, and Halation, a red-orange halo around bright lights as on motion-picture film, each with its own strength setting. The framing options can now either crop the JPEG or only mark the composition, while RAW files keep the native 3:2 frame. You can also import your own .cube LUT or Lightroom preset through the project’s website.
GRKit has been tested on the GR III and GR III HDF with firmware 2.10 and 2.20, the GR IIIx and GR IIIx HDF with 1.60 and 1.70, the GR IV and GR IV HDF with 1.11 and 1.20, and the GR IV Monochrome with 1.00, which gets no film looks. It now also supports Ricoh’s newest firmware for each model (2.21, 1.71, 1.21, and 1.10 or 1.11 for the Monochrome), but these versions are not yet tested on a camera. It takes 8 to 10 seconds to load after power-on, during which the camera uses its own settings. A new optional fast-start firmware shortens this. You make it on the GRKit website from Ricoh’s official firmware file and install it as a firmware update, and GRKit itself still runs from the card. Note that this option does change the camera’s firmware. The developer warns that installing it turns on the camera’s SD script setting, which stays on, and that the camera can hang at startup if GRKit fails, so the recovery guide is required reading.
The other two Ricoh projects change the firmware itself. GR4-MonoUnlock brings the six black-and-white looks of the GR IV Monochrome to the standard color GR IV: Standard, Solid, Soft, High Contrast, Grainy and an experimental HDR Tone, all available in Image Control and in-camera RAW development. Standard, Solid and High Contrast also work in movie mode. The tool takes Ricoh’s official GR IV firmware 1.11, checks that it is the genuine file, writes a patched version, and you install it through the camera’s normal update menu, which then shows an update from 1.11 to 1.11. Going back means installing the official file the same way.
GR Mod is a desktop app that now supports the GR IV and GR IV HDF on firmware 1.11, 1.20 and 1.21, the GR IV Monochrome on 1.10 and 1.11, the GR III and GR III HDF on 2.10, 2.20 and 2.21, and the GR IIIx and GR IIIx HDF on 1.60, 1.70 and 1.71. The app offers only the features that the selected firmware supports. It goes much deeper: up to eight aspect ratios (65:24, for example, gives 6192 x 2272 JPEGs), soft focus on the ADJ lever, a date imprint, up to twenty added Image Control slots built from imported .cube or .xmp presets, a halation effect, the monochrome looks on the color models and a Direct Flash mode that calculates exposure from the guide number and the focus distance. Its documentation is extremely technical, down to memory addresses, and it includes one honest example of what can go wrong: an earlier version placed soft focus in a slot that the official firmware reads past, and the camera froze. The current version includes a settings guard that resets unknown values to factory settings to prevent exactly that.
On the first-generation Hasselblad X2D 100C, autofocus has been the most discussed weakness, and that is where the community work started. The Hasselblad X-System firmware research project documents its findings with exact validation limits for each camera, and the related X2D/907 One-Click Extension Toolkit turned them into an experimental Mac and Windows app for the X2D 100C and the 907X and CFV 100C on stock firmware 4.2.0. Its feature list included AF-C continuous autofocus, AF-T face tracking, a separate eye recognition switch, three focus speed levels, automatic rear screen brightness and, on the X2D 100C only, a pixel-shift drive mode for sequences of 4, 6 or 16 RAW frames, which you merge on a computer.
The research notes were careful about what this means. Reaching the stock continuous-focus state on the camera, the project said, “does not establish focusing performance”, and one test that changed an autofocus parameter reduced hunting but caused false focus and was retired. The toolkit also asked users to run its one-click restore before updating the software, with the same computer and version, and to keep the backups until the restore is confirmed.
There is an important update here. When I checked both projects again on November 6, the research repository showed only a short note in Chinese, and the toolkit’s GitHub page was no longer reachable. When I looked again on November 16, the note gave a reason: according to the developer, public release stopped at Hasselblad’s request. If you installed the toolkit, keep your backups and the restore files, because there is no public source for them at the moment.
For the X2D II 100C, developer Jimmy6Smiles has published the source of a six-frame 400MP pixel-shift extension with reconstruction inside the camera, output in RAW, JPEG or RAW plus JPEG, playback with zoom and a recovery routine after a reboot. It was built for firmware 1.3.16.2, and an adaptation for 1.3.18.1 is included, with a successful capture reported by the maintainer. The repository is a source snapshot, not an installer, and the developer advises against using it for irreplaceable work, since experimental extensions “can cause failed captures, unresponsiveness or data loss”.
The newest project in this part is for FUJIFILM. FujiMod by developer Jake started with the X70, FUJIFILM’s compact APS-C camera from 2016 with a fixed 18.5mm f/2.8 lens, and it adds 23 features. The list reads like a wish list from other cameras: a highlight-weighted metering mode and snap focus, both inspired by the Ricoh GR III, aspect ratios up to 65:24 and 17:6 with a masked, darkened or white surround, an ULTRAFINE JPEG setting, adjustable noise reduction, a RAW view for highlights, golden-ratio and dynamic-symmetry framing guides, and approximations of film simulations such as ETERNA, Classic Neg., Nostalgic Neg. and REALA ACE, plus a film editor. For video, the list includes F-Log recording, HDMI output of the shooting view and an anamorphic de-squeeze from 1.25x to 2.0x.
You can run FujiMod from an SD card in a dual-boot setup, without flashing the camera, or install it as a firmware update. As with the other patched-firmware projects, the website builds the mod in your browser from the official FUJIFILM firmware file that you download yourself, and you can even try it first in a browser emulator. The developer is open about its status: not every feature has been tested on a camera yet, and the first release is meant for X70 owners who want to help test it. The tools are on GitHub, but the mod itself is not open source yet. Other cameras with the same EXR Processor II, such as the X-T10, X-E2S and X100S, are listed as work in progress. On November 18, the developer put the website into an “under construction” state ahead of a new release, and the SD card downloads are offline for now. The new site already describes more features, among them a halation effect, film recipes that you select by name, a digital teleconverter, different menu styles and dials that you can assign to other functions.
FujiMod is also the project that photographers have started to post results from. Danish photographer Jonas Rask shared street photos taken with it on Instagram and called it “a completely new camera”. The developers work together on the Discord server of Fujihack, the older FUJIFILM research project, which itself still says on its website that there are no hacks ready for public use.
My guess is that two things make the GR and the X2D attractive targets. Both have very loyal owners who use them as everyday cameras, and both have features on a sister model or competitor that owners want: the Monochrome looks on the color GR IV, or the AF-C and pixel-shift modes that photographers know from other medium-format and full-frame systems. In both cases, the hardware is the same and the feature is a software decision. (Ricoh, selling the Monochrome profiles as an official paid upgrade for the color GR IV would probably make more people happy than angry.)
All projects in this article are free, and GR Mod, GRKit and GR4-MonoUnlock publish their source code. FujiMod publishes its tools, but not yet the mod itself. The FUJIFILM X70 is discontinued and available only used. Installing modified firmware may void your warranty, and an interrupted update can leave a camera that needs manufacturer service, as the GR4-MonoUnlock documentation states. At B&H, the Ricoh GR IV costs $1,596.99, the GR IV HDF $1,696.99 and the GR IV Monochrome $2,196.95. The Hasselblad X2D II 100C costs $7,799, and the first X2D 100C is discontinued. For more information, please visit the Ricoh Imaging and Hasselblad websites.
Would you install a community mod on a camera as expensive as an X2D II? Which of these features would you like to see from Ricoh or Hasselblad officially? Let me know what you think in the comments below!
More from our camera firmware hacks series: the overview, fpSup on the SIGMA fp, the Sony a7 IV shutter-angle hack, Wonder Lantern on the Nikon Z30, Magic Lantern and the film-look projects on Canon DSLRs and NikonFirmwarePatch on the Nikon Z8.
Δ
Stay current with regular CineD updates about news, reviews, how-to’s and more.
You can unsubscribe at any time via an unsubscribe link included in every newsletter. For further details, see our Privacy Policy
Want regular CineD updates about news, reviews, how-to’s and more?Sign up to our newsletter and we will give you just that.
You can unsubscribe at any time via an unsubscribe link included in every newsletter. The data provided and the newsletter opening statistics will be stored on a personal data basis until you unsubscribe. For further details, see our Privacy Policy
Nino Leitner, AAC is Co-CEO of CineD and MZed. He co-owns CineD (alongside Johnnie Behiri), through his company Nino Film GmbH. Nino is a cinematographer and producer, well-traveled around the world for his productions and filmmaking workshops. He specializes in shooting documentaries and commercials, and at times a narrative piece. Nino is a studied Master of Arts. He lives with his wife and two sons in Vienna, Austria.