NEW PODCAST: Are Modern Sensors Too Clean? | DJI SDR Transmission 2 Field Tested – Focus Check ep137 →🎙️ WATCH/LISTEN Now
Watch/Listen NowAre Modern Sensors Too Clean? | DJI SDR Transmission 2 Field Tested🎙️NEW PODCAST
Education for Filmmakers
Language
The CineD Channels
Info
New to CineD?
You are logged in as
We will send you notifications in your browser, every time a new article is published in this category.
You can change which notifications you are subscribed to in your notification settings.
Tilta is putting up prices on 40 products at the start of September, and the increases are steeper than the usual inflation nudge. The Nucleus Auto Focus Adapter, the entire Boulder Camera Cart accessory range, the Hydra Alien Mini kits, and the Khronos Focus PD Handle are all affected, with individual items climbing anywhere from 6 percent to more than double. Anyone with a Tilta shopping list has one week of the old pricing left, and the small parts are where it stings most.
The new prices take effect on September 1, 2026, with current pricing active through August 31. Tilta attributes the change to sustained increases in raw material, production, and international logistics costs. Across the 40 SKUs on the list, 27 belong to the Boulder Camera Cart and its accessory ecosystem, eight cover the Hydra Alien Mini kits, three are Khronos Focus PD Handle colorways, and two are the Nucleus Auto Focus Adapter kits. Tilta has also confirmed that existing and pending Nucleus Auto Focus Adapter orders placed before September 1 will be honored at current pricing, which matters given that the adapter itself is only now reaching customers. The full SKU list is published on Tilta’s news page.
The headline number for most CineD readers is the adapter. The Nucleus Auto Focus Adapter Base Kit (E to PL) goes from $299 to $399, an increase of just over 33 percent, while the Dual Nano II Motor Kit moves from $499 to $599, a flat 20 percent. When we covered the launch in February, pre-orders opened at $269, so the September figure sits close to 50 percent above where early buyers came in.
That is a meaningful shift in the product’s competitive position. The adapter’s whole pitch, from the prototype we saw at Inter BEE onward, was that it undercut LiDAR-based autofocus systems by tapping the camera’s own phase-detection data and driving Nucleus-M II or Nano II motors rather than adding a separate sensor package. At $399 for the adapter alone, plus motors, the gap to competing PL autofocus solutions narrows. Tilta’s own product page lists the adapter as shipping from September 1 or later, which means the price change and the shipping date land on the same day. Buyers already in the queue are protected; buyers joining after that date are not.
Percentage-wise, the sharpest increases are on the cheapest items, and that is where a cart build quietly gets expensive. The 1/4″-20 mounting straps for the Boulder Camera Cart (yellow, purple, and gray) all go from $5 to $9, as does the Compact Hook: an 80 percent jump on parts most people buy in multiples. The Cable Management Storage Bin rises from $19 to $29, the Dual IGT Plate Kit from $22 to $29, and the two-panel Sunshade for the Extended Umbrella from $49 to $79, an increase of more than 61 percent.
The carts themselves move more modestly. The Boulder Camera Cart in gray goes from $1,199 to $1,399, the Indie Kit from $1,499 to $1,699, and the Boulder Camera Cart XL from $1,599 to $1,699, the last of those a comparatively mild 6 percent. The Motorized Control Kit for the US market goes from $699 to $799.
Because the Boulder platform is sold as a base plus modules, the compound effect is worth doing the arithmetic on. A cart specced with the Monitor Mounting Kit ($249 to $299), a locking Top Drawer ($139 to $159), a Metal Pegboard ($49 to $59), an Organizer Bin ($39 to $49), and the IGT Plate Expansion Module Kit ($219 to $249) currently totals $1,894. From September 1, the same configuration comes to $2,214, roughly $320 more, or an increase of nearly 17 percent on the build rather than the 16.7 percent on the cart alone. The rest of the accessory range follows a similar pattern: the Desktop Mounting Adapter climbs from $49 to $69, the IGT Outdoor Expansion Module from $199 to $229, and the 150mm Fluid Head Ball Mount Adapter Kit from $109 to $129.
The Khronos Focus PD Handle for iPhone is the most unusual entry on the list, because the three colorways do not rise by the same amount. Space Gray and Black both go from $99 to $149, an increase of just over 50 percent. Titanium White, however, moves from $74 to $149, which is slightly more than a doubling. In practice this reads less like a straight cost pass-through and more like Tilta normalizing a range that had drifted apart, with the discounted white version pulled back up to parity. Anyone eyeing that finish alongside the rest of the Khronos ecosystem has the strongest incentive of anyone on this list to order before the end of the month.
Every Hydra Alien Mini SKU on the list rises between roughly 21 and 28 percent, with no outliers in either direction. The Car Mounting System goes from $119 to $149, the Handheld Kit from $109 to $139, the Biking Kit from $139 to $169, the Ultimate Kit (Forest Green and Desert Beige) from $169 to $209, and the Master Kit in both colors from $199 to $249. The Electronic Suction Cup Kit moves from $149 to $189. The uniformity across the line suggests a category-wide cost recalculation rather than SKU-by-SKU repricing, which fits a product family built around machined arms, springs, and suction hardware. We took a first look at the Hydra Alien Mini at IBC 2024, where it launched as the lightweight sibling to the full-size Hydra Alien for action cameras, phones, and stripped-down mirrorless rigs.
Gear buyers are now facing two independent cost pressures at once. On one side sits the global memory shortage that “helped” shift the camera market toward pricier gear overall. On the other sits the older, less glamorous story of metal, machining, and container rates, layered on top of the tariff-driven increases the industry has been absorbing since last year. Support gear is exposed to the second, not the first.
One regional caveat is worth noting: the announcement is denominated in US dollars and published on Tilta’s North and South America storefront. The company operates separate European and UK stores, and the notice does not state whether or how pricing in those regions changes. Readers outside the Americas should check their local Tilta storefront rather than assume the dollar figures translate directly.
Current pricing on all affected items runs through August 31, 2026, with the new figures live from September 1. Existing and pending Nucleus Auto Focus Adapter orders placed before that date are honored at the old rate, and the complete SKU list is available on Tilta’s site. In the US, the Nucleus Auto Focus Adapter Base Kit and the Dual Nano II Motor Kit are also listed at B&H.
Is there anything on this list you were planning to buy anyway, or does an 80 percent jump on a $5 mounting strap change how you build out a cart? Don’t hesitate to let us know in the comments below!
Δ
Stay current with regular CineD updates about news, reviews, how-to’s and more.
You can unsubscribe at any time via an unsubscribe link included in every newsletter. For further details, see our Privacy Policy
Want regular CineD updates about news, reviews, how-to’s and more?Sign up to our newsletter and we will give you just that.
You can unsubscribe at any time via an unsubscribe link included in every newsletter. The data provided and the newsletter opening statistics will be stored on a personal data basis until you unsubscribe. For further details, see our Privacy Policy
Johnnie Behiri is a documentary filmmaker with more than three decades behind the camera: he learned the craft in daily television news gathering, filmed for Japan's public broadcaster NHK, and spent eight years shooting and editing for BBC News. He joined cinema5D in 2011 and has co-owned and co-run CineD and MZed ever since. Johnnie writes many of CineD's camera reviews, co-hosts our weekly Focus Check podcast, and heads CineD's manufacturer relationships and product development.